How to Remove a Door Window in a 2001 Ford F 250

The 2001 Ford F-250 Super Duty pickup is the mid-sized truck in Fords non-commercial F-Series fleet. Ford offered the 2001 F-250 with three different cab configurations: standard, super cab and super crew. If the door window glass incurs a scratch or chip, youll most likely need to replace it. An auto glass company can buff out surface scratches that arent deep enough to catch on your fingernail. Anything deeper than that requires window replacement. Always use caution when handling auto glass as the sheer weight of the glass if dropped and broken can deliver life-threatening lacerations in the blink of an eye.

Instructions

1

Open the F-250s window fully. Pry the sail panel trim off the F-250s door. The sail panel is the triangular trim piece located at the leading upper-edge of the door panel, on the backside of the doors A-pillar.

2

Pry the window and lock switch off the door panel using the trim tool. Disconnect the body harness from the switches and then set the switch bezel aside.

3

Pry the courtesy-light lens off the bottom trailing-edge of the door panel using the trim tool. Remove the hex-head screw behind the window switch bezel and the courtesy-light lens using the socket wrench and 7 mm socket.

4

Lift the door panel off the door by hand. Unplug the courtesy light from the body harness before moving the panel away to a safe location.

5

Lift the window to the top of the window frame --- you may need to temporarily reconnect the window switch to raise the window electronically. Secure the window to the top of the frame using packing tape. Unbolt the window glass from the window regulator using a socket wrench and 8 mm socket.

6

Support the window glass with one hand while removing the packing tape with the other. Lower the glass far enough to grab the top of the glass with both hands from the outside of the F-250. Tilt the glass forward and lift it up and out of the F-250s door through the outside of the window.

7

Set the old glass down in a safe location. Tilt the new glass forward and slide it down into the door from the outside. Tilt the glass back into the door, so it sits level and then raise it to the top of the window frame.

8

Secure the new glass to the top of the door with packing tape. Bolt the new glass to the window regulator using the socket and wrench. Remove the packing tape.

9

Reconnect the window switch temporarily and lower the window down into the door. Disconnect the switch. Slide the door panel onto the door.

10

Reinstall the two door-panel retaining screws with the socket wrench and 7 mm socket. Snap the courtesy-light lens into the door panel.

11

Plug the window and lock switches into the body harness, and snap the window switch bezel back into the door panel. Reinstall the sail panel by snapping it back into place. Clean the new window glass with a cotton rag and automotive window cleaner.

Related Posts by Categories